I got a GC RGB cable and removed the 3 capacitors from the Red, Green & Blue channels and also noticed that there was no connection to pin 16 (the RGB switching pin!). I added a 100ohm resistor between pins 8 (AV switch pin) & 16 (RGB switch pin) and attaching the switching cable to pin 8. When using the cable on a PAL GC, it sucessfully switched to the correct AV setting and to an RGB picture but didn't do either of these when using an RGB Modded US N64 or a US SNES. I checked the voltage between pin 18 (Video ground) and pins 8 & 16 and both showed 2.7V which should be enough to switch my TV to the correct settings...any suggestions?
Thanks
Dan
Thanks
Dan
Comment