See-through N64 & RGB modding

[Geoff D]

My Jpn N64 appears to have died so a replacement is needed - I quite fancy one of the see-through colour models, but need to know if the RGB mod can be performed on them.

Anyone have one done?

If not, is S-vid the best connection method?

Thanks in advance

[thebuddahman]

I think the RGB mod is possible on all of the JPN/US N64 models but don't hold me to that!

I the transparent N64's!

[chaoticjelly]

The later models wont work, you'd have to check the VDC markings to be sure..

[halfacandan]

You could always just put an RGB-moddable board into a transparent case. N64s are so cheap it probably wouldn't cost you too much.

Dan

[Shadow_Zero]

What exactly is the difference between an US and JAP N64?
Just the game cartridges?
But if you wider/open the insert slot of the US machine it will fit JAP games and plays them without a problem? (or was it the other way around...)

[alxbly]

^ The difference between JPN/US games is basically just the size of the tabs cut out the back of the cartridges. The photo below shows a Japanese and US cart.




In regards to the RGB mod... I dunno.

[t-bone-retro]

I the transparent N64's!

Likewise - me got Purple and Blue so far but I want one of the two tone versions 8)

[Distant Cousin]

May as well ask here rather than start a new thread...

Is there a 60Hz mod available for PAL N64s?

[sj33]

May as well ask here rather than start a new thread...

Is there a 60Hz mod available for PAL N64s?

I believe video mode is dictated by the software.

[charlesr]

You can run ntsc games in 60hz on your pal n64 with a passport converter thingy. Probably