I got an xecuter 2.2 lite+ and was happily going about installing it in my xbox. Anyway I read that you have to scrape around the d0 point to get the pogo pins in properly. Anyway I think I went overboard with the scraping since I broke one of the tiny wires in the motherboard that goes to a small hole beside the d0, that gaps only a couple of millimetres though...... (also the d0 doesnt look like its in the best of shape now). Now I cant get the mod chip to work and when I turn the xbox on without the chip in it starts and switches off 2 times then the third time it stays on with the button flashing green and red and no picture on the screen.
Anyway , I know this isnt exactly the right forum for this question but I have seen certain people here refered to as xbox modding experts and I'm just desperate to get some advice about this. ANY help at all would be greatly appreciated since I havent got nearly enough money to go replacing the xbox .
Anyway , I know this isnt exactly the right forum for this question but I have seen certain people here refered to as xbox modding experts and I'm just desperate to get some advice about this. ANY help at all would be greatly appreciated since I havent got nearly enough money to go replacing the xbox .